Forums / Street Legal Racing Redline / Help / how i can combine two engine parts?

 
 



 

 
 

 
 

Author Message

9kRPM

ar
Posts: 50

Location: Argentina
Occupation:
Age:
V$:
#1   2016-01-02 00:22          
I have the brazilian engines mod that replace the original i4 engines, and i have dual webers with the intake carb mod. One of the cylinder heads is "Promods high rpm", this cylinder head is compatible with the sport block, but dont support the intake carb. How i can combine intake carb with Promods high rpm cylinder head?
--------------------------------------------------------
youtube.com/9kRPM
Discord: 9kRPM#6366
--------------------------------------------------------

Lagano

si
Posts: 1739

Location: Slovenia West side
Occupation: Taking it easy
Age: 24
V$: :$V
#2   2016-01-02 12:05          
As far as i know, you can only combine parts from the original engines.

Bigg Boss93

it
Posts: 4024
http://rdbl.co/1Hmg5XL
Location: Italy - Sardegna
Occupation: Swimming out of the shit pool
Age: 30
V$: More than you can afford, pal.
#3   2016-01-02 14:13          
It's a cfg work;
> open the cfg of any cylinder head that supports those webers
> open the cfg of the other cylinder head and of the weber
> copy the attach/compatible slot from the first cfg to the second

It should work straight away, if not, you will have to set the second head's typeID on weber's slot.. i would post an example but i'm writing from phone.
With so much drama in the V-S-T, it's kinda hard being Bigg B-O-double-S-ninetythree B)




9kRPM

ar
Posts: 50

Location: Argentina
Occupation:
Age:
V$:
#4   2016-01-02 20:19          
# Bigg Boss93 : It's a cfg work;
> open the cfg of any cylinder head that supports those webers
> open the cfg of the other cylinder head and of the weber
> copy the attach/compatible slot from the first cfg to the second

It should work straight away, if not, you will have to set the second head's typeID on weber's slot.. i would post an example but i'm writing from phone.

I was reading the cfg's and i concluded the following: attach takes the ID of the part who want to join to the part of these cfg. For example, cylinder heads dont join to intake, the intake join to cylinder head, the cylinder head join to block, etc.

I put attach line with the cylinder head ID in the intake4carb.cfg, and compatible line with intake4carb ID in the cylinder head cfg, but donts works. All cylinder heads cfg that support intake4carb dont have ID's or any relation to intake4carb.cfg

Here are the cfg files edited
--------------------------------------------------------
youtube.com/9kRPM
Discord: 9kRPM#6366
--------------------------------------------------------