After a good night, the mold is dried and the holes are drilled in the trunk to fit the Mazdaspeed wing :
Carefully bolting on the wing.
Even more carefully remove the mold from the roof.
Then at last filling the inside of the mold with carbon fiber, then lay to rest until it's hardened, cut the exceed aaaaand voilà you have a carbon fiber roof!
While it's drying i decided to take a spin near the beach with the Chevy, i think i'll have more chance to sell it to a rich surfer boys than dockers in the harbour.
See you soon for the final result on the RX-8
end of the page
This post was edited by NK748 (2016-01-25 17:23, ago)
