I did some changes to the S14's interior today. Replaced the old stock seats with some aftermarket Bride bucket seats and a Momo steering wheel, because drift car.
And I have finally decided what I'll be doing with the Golf, it's something a bit different than what we've seen here.
I put it up on the stand and took off basicly all the suspension, I'll be working on the bottom of the car to achieve something, which you'll see later.
Added 13 minutes later:
Now, about the VStanced plates.
To add a slot to any car, you must open the car's folder and look for the .cfg (under scripts folder) of the part you want to connect the plate to. This can be any part, not necessarily a bumper, but keep in mind it needs to be on the car so you can connect the plate to it.
Now you have to copy this:
and place it amongst the other slots in the .cfg and it should look something like this.
For the rear plate slot, simply change the 3.147 to 0.000, what this does is rotate the plate so it faces backward.
I also would like to say the plate will most probably be massively out of place, so you'll have to edit that with the tools in the game. It's just something you'll have to deal with. If you can't see where the plate is, move the part it's attached to and you should find it.
And that's it, you can now place VStanced plate on your car, if it couldn't before. I would like to thankBigg Boss93for telling me how to do this
This post was edited by MartyTheGamer (2015-05-01 12:42, ago)
