Forum
Questions, builds, help and the odd argument. The mods and guides are out front.
Won't moving the wheels and the axles do the job?
Well, if you want to move whole everything for it, then yes.
It's easier to move chassis only though.
I see...
By the way, do you have any clue as to why the parts aren't properly assigned to the chassis?
a) You've moved them
b) You have to fit them by cfgs.
1) They're properly aligned in 3DS
2) What did I do wrong?
Basically, all parts are assigned by .cfg files, not 3DS Max possition 😉
What about the chassis?
The chassis can't be moved easily in CFGs with respect to the pivot point.
It's actually best to export all of the parts as close to the coordinate center as you can get them - e.g. make a standard position to export all front bumpers from, another for all rear bumpers, etc - but not everyone does this.
If you export all of the parts centered to the same pivot, you get something like Blast's SRT-4 where the physics end up weird, and the parts look tiny and far-away in the catalog.
Followed Harrison's advice for the whole chassis thing. Chassis is still flying though...
Also, headlights are being bitches and won't align properly. Will fix.
Now, here's a list of stuff to do:
1) Separate the bumpers into parts. Without the grille, the bumper is paintable.
2) Lower the chassis itself and separate it into parts
3) Learn how to work with pivots
4) Fix positioning of parts so they can open normally and not like retards
5) Check to see if any materials are wrong.
You may need to move it down more than that, then. Try 100 if 50 isn't enough (maybe you're in centimeters instead of inches or something silly like that?).
Just the chassis or the whole thing?
Added 1 hour 19 minutes later:
Nvm. I did it.
Only thing that bugs me is the rear bumper being a very little tad off.
There's still a long way to go.
Looks good!
What did you do to position the bumper? I might be able to help you with that.
I took the coordinates from Max with the script, pasted on the main.cfg, then I went to the bumper.cfg and reset its coords to 0.000
Okay, good. Sounds like you've got it right.
I think it might just be because the indicator is missing a texture? The bumper actually looks fine.
Also make sure that there aren't more decimal points getting cut off. (Try pressing F12 with the Move tool selected and the bumper selected, and looking at the numbers - although, there would be a conversion factor between Max and SLRR, usually with Max's units being 100x SLRR units and with the Y and Z jumbled around.)
sweet progress man, so good to see everything working as it should 😃