indestructible engine

Runaeh

i know but it still breaks

Added 6 hours 39 minutes later:

there isnt like a limit for it so you can make so it never breaks?

JUDAS_MENTOR

# Runaeh :
i know but it still breaks

Added 6 hours 39 minutes later:

there isnt like a limit for it so you can make so it never breaks?

its called my 1.5JZ :troll:

try upping max wear on....
connecting rods
pistons
turbo
maybe edit efficiency on intake manifold? I run 3.40

Runaeh

i have wear at 999999km so 😃 ill try that 🙂 btw look at your inbox 🙂

Added 1 minute later:

my efficiency 0.95; what does it do? 🙂

Added 13 minutes later:

i dont wanna gain more horsepower than it has, it should just sit at around 1000hp-1090hp no nos no race gas etc

JUDAS_MENTOR

# Runaeh :
i have wear at 999999km so 😃 ill try that 🙂 btw look at your inbox 🙂

Added 1 minute later:

my efficiency 0.95; what does it do? 🙂

Added 13 minutes later:

i dont wanna gain more horsepower than it has, it should just sit at around 1000hp-1090hp no nos no race gas etc

it helps air flow, it's not a supremely noticeable mod but I believe it helped with throttle response, I'm using an xbox 360 controller and well it just felt right ^__^

Gaveup

Increasing efficiency on head ports/intake manifold/exhaust manifold will increase the performance on these parts you can go above 1.0, it's why the carb intakes and carbs work better from the blackseries parts compared to the base intake manifolds and fuel rails, fuel rails also have their own settings for fuel consumption and such that I haven't started messing with but adding fuel to the consumption parts and having high intake efficiency lets you run some massive boost.

JUDAS_MENTOR

# Gaveup :
Increasing efficiency on head ports/intake manifold/exhaust manifold will increase the performance on these parts you can go above 1.0, it's why the carb intakes and carbs work better from the blackseries parts compared to the base intake manifolds and fuel rails, fuel rails also have their own settings for fuel consumption and such that I haven't started messing with but adding fuel to the consumption parts and having high intake efficiency lets you run some massive boost.

some stock parts are rated at 0.67 efficiency! Insane-o poor by tweaking my JZ to have 1JZ head with 2JZ block and my custom connecting rods, pistons, 87.1mm bore and 94mm stroke mod I went from a poor 6800rpm max redline to a 10,000RPM peaking out 23lbs (1.58bar) turbo pressure with 18lb wastegate, I constantly tap boost at 8800RPMs hitting rev limiter and never have any heat or wear problems, also running reverse stagger TRD N2 spec cams 304/10.8mm lift intake with 320/11.0mm lift nasty mid end and lower response all the way to high end. This is on my 1.5JZ S13. I also want to find out what is the formula for the fuel consumption so I.E. Stock maybe is equivalent to 160lph and could mod to a spec of walboro 244lph, some guys in real life run twin walboros so theoretically if you wanted to replicate that you can double or triple the fuel consumption value.

Runaeh

danm you have done some stuff lol, btw is there any good 1jz released, the vip one is to high poly i dont like it 🙂

Added 31 minutes later:

unload: Undefined GameType Destructor! 00A800C1 (Rf) i get this error now when i am trying to go to valo :/

JUDAS_MENTOR

I believe the VIP 1J is the one I tweaked, I might upload it if the Jeezus gives me permission :troll: I don't believe it is too high poly but I play on my home entertainment centre. XD

in regard to the Valo problem, I am not sure. I NEVER drive Valo due to the fact it takes 2-3 minutes to load and it is laggy 🙁

Gonna post my controller settings soon, just got out of Academy.

Runaeh

valo is OP, just do the loading order then its perfect🙂, i did release all vip mods but got banned for it ;D did it without permission 🙂 i learned from it 🙂

Added 3 minutes later:

do you btw know how to set steering sensitivity to a custom value since i want it lower than you can ingame, and is there like traction control/ assist in the game?

JUDAS_MENTOR

Meh I figured that's why I don't do it that and I don't for the respect of the authors of the cars/parts, it's just nice to have them as being a big car enthusiast it makes the game more enjoyable!

Lol I know the valo trick but mehhhhhhh much wait, so lag. Lololol

Runaeh

do you btw know how to set steering sensitivity to a custom value since i want it lower than you can ingame? 🙂

« Previous Page